Danish Oil 2 Ounce Bottle Pipe Maker Formula

This Danish Oil is special formulated for Briar.  It contains Polymerized Tung Oil and a resin in a refined mineral spirit.

Directions for Smooth surface:

1. Sand up 600, 800, or 1000 and dry wipe the surface clean.
2. Apply a heavy coat of oil with either a brush or pipe cleaner or cloth.
3. Let it dry for about 5 to 10 minutes or until tacky to the touch, then wipe heavily with a cloth to remove the excess.
4. Allow for it to cure in a room temperature or slightly warmer enviroment that is not humid for 3 to 10 days.  (a mild fan blowing over it will quicken up the curing process)
5. Polish with red then white then wax on a buffing wheel for a super shine. (you may not buff it for a more satin finish)

Directions for a rough or sandblasted surface:

1. Apply very lightly with a brush.
2. Let it sit for 2 minutes and then wipe clean with either our wood finishing cloth or similar non fuzz cloth.
3. Allow for it to cure in a room temperature or slightly warmer enviroment that is not humid for 5 to 12 days.  (a mild fan blowing over it will quicken up the curing process)
5. Polish with wax lightly on a buffing wheel.

Proper Handling and Precautions:
1. Use in a well ventilated area
2. Discard brushes and rags in a fire safe disposal
3. Keep away from heat and sunlight
4. Wear protective equipment when handling. Gloves, eye protection, etc..

WARNINGS:
THIS MATERIAL IS CONSIDERED TO BE HAZARDOUS
COMBUSTIBLE:
MATERIAL CAN RELEASE VAPORS THAT READILY FORM FLAMMABLE MIXTURES. VAPOR
ACCUMULATION COULD FLASH AND/OR EXPLODE IF IGNITED. MATERIAL CAN ACCUMULATE STATIC CHARGES WHICH
MAY CAUSE AN IGNITION.
POTENTIAL HEALTH EFFECTS:
REPEATED EXPOSURE MAY CAUSE SKIN DRYNESS OR CRACKING. IF SWALLOWED, MAY BE ASPIRATED AND
CAUSE LUNG DAMAGE. MAY BE IRRITATING TO THE EYES, NOSE, THROAT, AND LUNGS.

KEEP AWAY FROM HEAT/SPARKS/OPEN FLAMES/HOT SURFACES.
CAUSES EYE IRRITATION
WASH THOROUGHLY AFTER HANDLING.
WEAR PROTECTIVE GEAR. PROTECTIVE GLOVES/PROTECTIVE CLOTHING/EYE PROTECTION/FACE PROTECTION.
EYE CONTACT - RINSE CAUTIOUSLY WITH WATER FOR SEVERAL MINUTES.  REMOVE CONTACT LENSES,
IF PRESENT, AND CONTINUE RINSING.

NOTE: THIS MATERIAL SHOULD NOT BE USED FOR ANY OTHER PURPOSE THAN THE INTENDED USE WITHOUT EXPERT ADVICE. HEALTH STUDIES HAVE SHOWN THAT CHEMICAL EXPOSURE MAY CAUSE POTENTIAL
HUMAN HEALTH RISKS WHICH MAY VARY FROM PERSON TO PERSON.

First Aid Measures:
EYE CONTACT:
REMOVE CONTACT LENSES. FLUSH WITH WATER FOR 15 MINUTES. SEE DOCTOR.
INHALATION:
MOVE TO FRESH AIR. SEE DOCTOR.
SKIN CONTACT:
WASH WITH SOAP AND WATER. LAUNDER CONTAMINATED CLOTHING BEFORE REUSE.
INGESTION:
CALL A DOCTOR IMMEDIATELY. DO NOT INDUCE VOMITING.
*NOTE TO PHYSICIAN: PERFORM GASTRIC LAVAGE IN ACCORDANCE WITH PROCEDURE FOR INGESTION OF
PETROLEUM PRODUCTS.*

Fire Suppression:
FLASH POINT: 104°F >400 ASTM-D-56
EXTINGUISHING MEDIA: CARBON DIOXIDE, FOAM, OR DRY CHEMICAL
SPECIAL FIRE FIGHTING PROCEDURE: COOL CLOSED CONTAINERS EXPOSED TO HEAT BY WATER.
USUAL PRECAUTIONS FOR COMBUSTIBLE LIQUIDS.

Accidental Spill:
STEPS TO BE TAKEN IN CASE OF SPILL OR LEAKAGE:
SMALL SPILLS - WIPE UP WITH RAGS.
LARGE SPILLS - USE NON-FLAMMABLE ABSORBENT. KEEP AWAY FROM FLAME OR SPARK.
WASTE DISPOSAL METHOD: LANDFILL OR INCINERATE IN ACCORDANCE WITH ALL LOCAL STATE AND FEDERAL
REGULATIONS.
EYE CONTACT: MODERATELY IRRITATING TO THE EYES. FLUSH WITH WATER.
SKIN CONTACT: PROLONGED OR REPEATED CONTACT WITH SKIN CAN BE MILDLY IRRITATING AND RESULT IN DRYING
AND IRRITATION, WASH WITH SOAP AND WATER.
INHALATION: HIGH VAPOR CONCENTRATIONS MAY IRRIATE RESPIRATORY AIRWAYS, NOSE AND THROAT.
INGESTION: DO NOT INDUCE VOMITING! SEEK MEDICAL ATTENTION.
NOTE TO PHYSICIAN: PERFORM GASTRIC LAVAGE IN ACCORDANCE WITH PROCEDURE FOR INGESTION OF PETROLEUM
PRODUCTS.